On units built prior to mid-July 2007 the serial number is underneath the main-board. You can use the feedback send and return to extend the length of a chain if necessary. Just press the RECALL button, page over to the EFFECT tab, select the proper preset to copy from, then select controller from the Retrieve area. In addition to copying effects block parameters, the controller parameters can also be copied (i.e, Envelope, ADSR, LFO, etc) from one preset to another. This is useful to get more drive out the amp than it would normally have. The boost switch adds 12db of gain to the amp simulation. The text “BOOST” will appear under the control when the boost circuit is active. This will toggle the state of the Boost switch. The "boost switch" of an amp (which adds 12db of gain) may be enabled selecting the DRIVE control and pressing ENTER. The text “BRT” will appear under the control when the bright circuit is active. This will toggle the state of the Bright Switch. The "bright switch" of an amp block may be enabled by selecting the TREB control and pressing ENTER. You can use this feature to find cool sequence patterns. Hold down BYPASS to restore all parameters of an effect block to default.Įach time ENTER is pressed while in the sequencer menu, a new random set of values is loaded. If you are on a different page, the edit page for the nearest effect will be displayed. Press and hold ENTER to automatically place and route shunts from the current position to the output mixer.Įach time EDIT is pressed, the next effect edit page is displayed.